Jump to the main content

Secure Checkout

Blog


Detroit Diesel Series 60 & 50 Camshaft Timing & Gear Alignment Steps

Precision overhead cam timing and front gear train alignment guidelines for commercial Detroit Diesel mechanics.

Step-by-step close up layout of M30138 camshaft timing tool mounted on a Detroit Diesel Series 60 cylinder head

Setting overhead camshaft timing after a cylinder head replacement, front gear train repair, or complete rebuild on a Detroit Diesel Series 60 or Series 50 engine? Follow this step-by-step professional workshop procedure to set Cylinder #1 at Top Dead Center (TDC), mount the M30138 timing fixture onto the cylinder head, engage the camshaft index slot, torque gear train fasteners, and verify free rotation.

Why Paint Marks & Straightedges Fail on Detroit Series 60 Overhead Cams

On Detroit Diesel Series 60 and Series 50 overhead-cam engines, timing precision relies on exact angular indexing between the crankshaft bull gear, adjustable idler gear assembly, and upper camshaft drive gear. Technicians who attempt to align camshaft timing using painted gear teeth or visual straightedges encounter frequent timing errors: minor cylinder head resurfacing, head gasket thickness variations, and gear backlash shift the camshaft's angular alignment relative to the block. Even a half-tooth or single-tooth error degrades fuel economy, triggers fault codes, or causes valve-to-piston interference. Utilizing the 7.00-pound M30138 Camshaft Timing Tool completely eliminates visual guesswork by indexing directly off the cylinder head deck into the machined camshaft timing slot—locking the camshaft in true factory TDC phase while gears are installed and torqued.

The 5-Step Detroit Series 60 & 50 Camshaft Timing Protocol

  1. Set Crankshaft at Cylinder #1 Top Dead Center (TDC): Rotate the crankshaft in the normal direction of rotation until the Cylinder #1 TDC timing mark on the vibration damper aligns precisely with the timing pointer on the front cover.
  2. Rotate Camshaft to Approximate TDC Index Position: With the rocker assemblies removed or backed off, position the overhead camshaft so its machined timing slot/hole aligns with the cylinder head timing fixture mounting location.
  3. Mount M30138 Timing Fixture & Engage Camshaft Slot: Bolt the M30138 Camshaft Timing Tool securely to the cylinder head mounting bosses and slide/engage its precision alignment tongue fully into the camshaft timing slot without forcing.
  4. Install & Torque Camshaft Drive and Idler Gears: Install the camshaft drive gear and set adjustable idler gear backlash per Detroit Diesel service manual specifications, then torque all retaining bolts while the M30138 fixture holds the camshaft locked.
  5. Remove M30138 Fixture & Perform 720-Degree Hand Bar Verification: Unbolt and remove the M30138 timing tool completely, bar the engine smoothly through two full crankshaft revolutions (720 degrees) by hand to confirm zero valve-to-piston interference, and re-verify TDC alignment.

PRO-TECH FIXTURE REMOVAL & 720° HAND BAR MANDATE:

ALWAYS REMOVE THE M30138 TIMING TOOL BEFORE BARRING OR CRANKING THE ENGINE! Turning the crankshaft with the timing fixture still bolted in place WILL shear the timing pin or damage the camshaft! ALWAYS BAR THE ENGINE 720 DEGREES BY HAND after timing setup to confirm interference-free rotation!

7.00 lbs Precision Detroit Diesel Series 60 & 50 Camshaft Timing Fixture. Lock Exact TDC Cam Phasing.

Get the M30138 Timing Tool Now

overall rating:
my rating: log in to rate

Back to Blog Home