Blog
Non-EGR Detroit Diesel Series 60 Cylinder Liner Removal Steps
Precision cylinder block preservation and wet liner extraction guidelines for commercial Detroit Diesel rebuilders.
Pulling wet cylinder liners during an in-frame overhaul on a Non-EGR Detroit Diesel Series 60 engine? Follow this step-by-step professional workshop procedure to verify Non-EGR engine application, position the M30143 (J-35791) puller jaws cleanly beneath the lower liner skirt, seat the bridge feet on the block deck, lubricate the forcing screw, and extract liners straight out.

Why Brass Drifts & Pry Bars Ruin Detroit Series 60 Blocks & Crankshafts
On Non-EGR Detroit Diesel Series 60 engines, wet cylinder liners are sealed by thick lower O-rings and top crevice seals that harden and bond to the cast-iron block over time. Technicians who attempt to drive seized liners upward from underneath using a hammer and brass drift bar risk severe mechanical damage: a glancing blow can dent hardened crankshaft counterweights or snap off delicate piston cooling nozzles. Likewise, prying upward under the upper liner flange gouges the machined block deck and cracks thin counterbore ledges. Utilizing the 12.00-pound M30143 Liner Puller Tool (Direct J-35791 Replacement) eliminates every extraction hazard by hooking squarely under the bottom skirt of the Non-EGR liner and drawing it straight upward along the cylinder axis.
The 5-Step Non-EGR Detroit Series 60 Liner Extraction Protocol
- Verify Non-EGR Engine Configuration & Remove Pistons/Nozzles: Confirm the engine is a Non-EGR Detroit Series 60 model, drain coolant completely, remove the cylinder head, extract piston/rod assemblies, and remove piston cooling nozzles to prevent clearance interference.
- Clean Block Deck & Lubricate M30143 Forcing Screw: Wipe debris off the cylinder block top deck where the puller bridge legs will rest, and apply heavy extreme-pressure (EP) grease to the M30143 central forcing screw threads and thrust bearing.
- Lower M30143 Puller into Bore & Hook Under Liner Skirt: Rotate the crankshaft so the rod journal is clear of the bottom of the cylinder, lower the M30143 puller down through the liner bore, and expand/position the lifting jaws squarely beneath the bottom rim of the liner skirt.
- Seat Bridge Legs Squarely on Cylinder Block Top Deck: Center the M30143 top bridge across the cylinder bore so both support feet sit flat on the solid cast-iron block deck (clear of adjacent liner flanges and head bolt holes).
- Advance Forcing Screw Smoothly to Lift Liner Free: Turn the central forcing screw clockwise with a hand wrench or ratchet to break O-ring and scale seizure, drawing the cylinder liner smoothly upward until it clears the lower block bore, then lift the puller and liner out together.
PRO-TECH NON-EGR FITMENT & PISTON COOLING NOZZLE MANDATE:
FOR NON-EGR DETROIT SERIES 60 ENGINES ONLY! Verify Non-EGR engine application prior to insertion! ALWAYS REMOVE PISTON COOLING NOZZLES AND ROTATE CRANKSHAFT THROWS CLEAR before lowering puller jaws below the liner skirt—and lubricate the forcing screw with EP grease before every pull!
12.00 lbs Heavy-Duty Non-EGR Detroit Diesel Series 60 Liner Puller Tool. Protect Block Counterbores.
Get the M30143 Liner Puller Now
overall rating:
my rating:
log in to rate